Practical Overhead Tank Cleaning Guide For Indian Homes
Learn overhead tank cleaning with exact ratios, bleaching powder paste application, scrubbing steps, and safe rinsing instructions for your home.
- Mix bleaching powder with water into a thick paste and apply it to tank walls for 20 to 30 minutes before scrubbing.
- Rinse the tank twice with fresh water and drain the rinse water completely before refilling for use.
- Use 5 to 7 grams of bleaching powder per 1000 litres of water for monthly routine disinfection.
How do you prepare and drain the overhead tank?
Stopping the supply
Turn off the main motor pump and close the inlet valve completely before you start. Let the water level drop by using taps downstairs until only a few inches remain at the bottom.Manual bailing out
Scoop out the remaining dirty water using a small bucket and a mug. Wipe away the final sludge near the drain plug with an old cotton cloth or a sponge. Leave the drain open so dirty water escapes outside instead of pooling on your roof.Inspecting the interior
Check the walls and ceiling for algal growth, rust patches, or peeling plaster. Grab your Shop Sabera Multi-Purpose Cleaning Powder if you need to tackle greasy sludge around the manhole cover first.How do you apply the bleaching powder paste?
Mixing the correct paste
Mix bleaching powder with a small amount of water into a thick paste using a roughly 50 to 50 powder to water ratio. Wear rubber gloves and a face mask because the chlorine smell is quite strong in closed spaces.Applying to surfaces
Coat the walls, ceiling, and floor of the tank thoroughly with this thick paste using a soft brush or a gloved hand. Let the paste sit undisturbed for 20 to 30 minutes so the active chlorine breaks down grime and biological buildup.Scrubbing the tank
Scrub all interior surfaces firmly with a stiff plastic brush after the waiting time passes. Rinse the tank with fresh water at least twice and drain the rinse water out completely before refilling with water for use. See our water tank care guide for more tips on keeping your storage clean between deep cleans.Never reuse the dirty rinse water from your tank cleaning process. Always drain it out completely away from your garden beds and living areas.
What are the correct bleaching powder ratios for water disinfection?
| Tank Maintenance Task | Dosage Required | Contact Time / Action |
|---|---|---|
| Routine Monthly Disinfection | 5 to 7 grams per 1,000 litres | Dissolve fully and let stand for 30 minutes before use |
| New or Contaminated Tank Shock | 150 to 300 grams per 1,000 litres | Let stand for 12 to 24 hours, then fully drain and rinse |
| Interior Wall Cleaning Paste | 50:50 powder to water ratio | Apply paste and let sit for 20 to 30 minutes before scrubbing |
| Routine Surface Wipe | Small paste amount as needed | Scrub and rinse twice with fresh water |



